Detailed Product Description

 The OnAccess 200X is a high performance, cost effective, carrier grade manageable media converter system, which is intended for applications of the point-to-point fiber-to-the-premises (FTTx) market or to bridge the gap between legacy copper infrastructures and fiber growth. Available in stand-alone, modular chassis-based, or fixed multiport, the OnAccess 200X media converter products offer copper to fiber and fiber to fiber media conversion in the following supported protocols: Ethernet, Fast Ethernet, Gigabit Ethernet, or other media and protocol conversion in the future releases.

With industry advanced features such as Auto-Negotiation, Auto-MDI/X, Link Fault Pass-Through (LFP)or Remote Fault Detection (RFD), and Dying Gasp Alarm  make more efficient troubleshooting and less on-site maintenance. The OnAccess 200X provides remote loopback and in-band TS-1000 or Ethernet packet-based OAM capabilities to manage subscriber access network from carrier center side to terminal side, while the embedded management software allows administrators to easily configure features, monitor performance, and troubleshoot the system using command line interface, standard Web browser and Simple Network Management Protocol (SNMP) based network management platforms.

Product Highlights

·         Each standard chassis containing up to 15 media converter (MC) slots plus one network management card (NMC) slot.

·         Up to 4 chassis managed by a single management unit with one master management card plus three slave management cards.

     

Each mini-chassis providing up to 6 media converter slots plus two media converter and power module shared slots and one network management card slot.

·         In-band network management (OAM) communication with TS-1000 standard or special Ethernet packet to manage subscriber access network from carrier center side to terminal side.

·         10/100BASE-TX to 100BASE-FX media conversion with fixed fiber optic module or SFP.

·         10/100/1000BASE-TX to 1000BASE-X media conversion using SFP module.

·         Multiple port 10/100BASE-TX to 1000BASE-X media aggregation.

·         Single fiber to dual fibers conversion.

·         Multi-mode fiber to single mode fiber conversion.

·         Variety SFP options for 100BASE-FX and 1000BASE-X with SFP internal ID and status monitoring capability.

·         Non-blocking store-and-forward architecture enables the forwarding rate to proceed at a full wire speed.

·         802.3x flow control for a full-duplex mode and collision-based backpressure for a half-duplex mode.

·         Egress/Ingress rate management control with 128Kbps granularity.

·         Optional automatic converter switchover protection.

·         Programmable link fault pass-through (LFP) or remote fault detection (RFD) function.

·         Remote power on / off detection with dying gasp alarm.

·         Remote loopback capability for link integrity test.

·         Dual processor management card for maximize the system performances.

·         Dual power supply of load sharing or 1 + 1 automatic over features with over-voltage / under-voltage alarms.

·         Dual fans with monitoring and alarm features.

·         Standard 19 inch rack mounted.

Network Application

Network Management

·         Remote In Band: SNMP, Web-based HTTP and Telnet.

·         Local Out of Band: RS-232 Console.

Network Protocol and Standards

·         IEEE: 802.3, 802.3u, 802.3z, 802.3ab, 802.3ah, 802.1p, 802.1q, 802.3ad, 802.3x

·         IEFT: RFC1157 SNMP, RFC854 Telnet, RFC 1123/1493/1643 MIB